Crimping Procedure - KNIPEX DigiCrimp 97 52 63 DG Mode D'emploi

Operating Instructions
Four-indent crimping tool DigiCrimp® with digital display and wear monitoring
Standard mm
Setting the crimping parameters
• Refer to the adjustment matrix for die settings and contact bushing positions (3) for the contact you
intend to crimp.
• Change the crimping die setting (crimping die depth) by turning the adjustment wheel until the digital
display shows the desired value.
• Lock the crimper setting using the locking screw (2).
• Lift and turn the contact bushing (3) to the side (see Figure 2) into the setting shown on the adjustment
matrix.
Figure 2
NOTE
Always set the crimper depth from a larger value, such as from 1.05 mm to 1.0 mm or from 2.05
mm to 2.0 mm.

3. Crimping procedure

• Feed the prepared cable into the connector
• Lay the contact with the cable into the crimper's crimping point until it will not go any further; the contact
bushing will position the contact exactly.
• Close the crimper until unlocking via the catch
• Open the crimper and remove the crimped contact
Rev.: 2016-06-10
Inch
Type CR 2025 battery compartment
Clamping screw
for locking the crimper setting
MIL selector
positions
EN
5 / 10