Campbell Hausfeld CL15 Serie Instructions D'utilisation page 5

Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any
maintenance on the air system. personal
injury and/or property damage could
occur.
IMpact MechanIsM luBRIcatIon
The impact mechanism must be
lubricated monthly.
the air supply before lubricating.
1. Disconnect the impact wrench from
the air supply.
2. Remove the slotted screw or allen
head screw from the oil port hole.
OIL
Figure 2 - Oil port hole location
the following instructions for all impact
mechanisms, excluding pin clutch:
3. Squeeze approximately 1 oz. of
Campbell Hausfeld air tool oil in the
oil port hole. Replace the screw.
4. Reconnect the air supply to the
impact wrench and run for 20 to 30
seconds. Lubricate the entire impact
mechanism by rotating the tool
upside down and sideways while
running the tool.
Disconnect the
impact wrench from
Oil Port Hole
www.campbellhausfeld.com
Cl15xx and Cl25xx series
5. Remove the screw and hold the oil
port hole over a suitable container to
allow excess oil to drain. Sometimes
triggering the tool when dumping the
oils helps to force out the excess oil.
6. Install the screw and tighten. The
residual oil remaining in the impact
mechanism chamber is all that is
needed for proper lubrication.
For pin clutch type impact wrenches:
Fill clutch housing halfway up with
Campbell Hausfeld compressor oil or
ISO-100 oil.
stoRaGe
The impact wrench must be lubricated
before storing. Follow the air motor
lubrication instructions with an exception
to step 4. Only run the impact wrench
for 2 to 3 seconds instead of 20 to
30 seconds because more oil needs
to remain in the impact wrench when
storing.
technIcal seRvIce
For information regarding the operation
or repair of this product, please call
1-855-504-5678.
ReplaceMent paRts
InFoRMatIon
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
5