Product specifications
Sensor
Horizontal resolution
Digital resolution
Total resolution
Objective
Sensitivity
Picture controls
Gain control
White balance
Video signal
Working distance
Magnifications
Microphone
Audio signal
Power supply
Switching on
PC link
Length of flexible arm
Base diameter
Weight
Assembly
Power supply
The Educam Multimedia video camera requires 15 V DC working voltage and comes with an external power pack. This
power pack needs to be plugged directly into a 220 V mains sockets and its output cable should then be plugged directly into
the video camera power supply socket.
Video and audio signals
The analog video signal from the Educam video camera is transmitted to a TV monitor and the audio signal to an amplifier or
an amplified monitor. The small video/audio output signal cable, that can be found on the back of the camera base, should
be connected as follows:
Red plug (video signal):
into the video input of your monitor/colour TV directly or via the SCART adapter provided (in the yellow video
socket).
Black plug (audio signal):
into the audio input of your amplifier system or into the audio input of your monitor/colour TV or via the SCART
adapter provided (in the white audio mono socket).
Using the SCART adapter, it has to be inserted into the SCART socket at the back of the TV set. See the TV
manufacturer's instruction manual for details of how to switch on the TV and use its SCART circuit.
Connect the USB cable that can be found on the back of the camera base, to the PC in order to view the digital
USB video signal (follow the instructions on next section to install the camera on your PC).
1/3" interline transfer colour CCD element
420 TV lines
640x480
307k pixel
8 mm, F:1.2
min. 0,08 lux at F:1.2
electronic shutter
automatic
automatic
PAL compatible - VHS
from 0,76 mm to infinite
90x at 0,76 mm (with 21" monitor)
built-in high sensivity microphone
analogic
15 V DC, 400 mA, with external power adapter
via 3-position switch
standard USB 2.0
65cm
17 cm
3.4 Kg
Page 4