Jette Jackson Manuel Du Propriétaire page 12

GB
Setting up:
Before you can set up the buggy, you must open the safety lock (fig. 1). Now pull the
sliding handles all the way up, so that the pram is fully upright (fig. 1a). Then, press
the lock all the way down (fig. 1c), until it quietly snaps into place. Check if all the
parts are stable before seating your child in the buggy.
Attaching the wheels:
In order to attach the front wheels, press them on to the wheel mounts on the frame,
until you can hear them click in place (fig. 2a).In order to detach the front wheels,
press the two tabs (fig. 2b) and pull the wheel from the mount.
Swivel wheel function:
Press the two plastic clips up in order to activate the swivel wheel function for the two
front wheels (fig. 3a). In order to fix the front wheels, press the two plastic clips down
(fig. 3b).
Applying the break:
In order to apply the break, press both break levers down (fig. 4a). In order to release
the break, press both break leavers upwards (fig. 4b).
WARNING: Please only apply the break using the purpose built break lever on the
right hand side of the wheel.
Adjusting the foot rest:
By pressing the two levers on the bottom right and left, the foot support can be posi-
tioned as required (fig. 5).
Safety belt:
In order to put on the safety belt, attach both belt clasps (A + B) on the middle belt
(C). In order to open the safety belt, press the side clips at the same time and pull
the belt clasps apart (fig. 6).
In order to be able to provide maximum safety for your child, adjust the length of the
belt to your child. The length of the belt should be adjusted in a manner that the belt
is resting tightly against your child.
Adjusting the back rest:
In order to adjust the position of the back rest, simply push down both adaptation
mechanisms on the sides and adjust the back rest until you've reached the desired
position (fig.7).