FOCUSEAT U-AH0075R02N3OTG Mode D'emploi page 5

5. Chair back to seat assembly.
A. Remove the four screws from the seat back using
the L Shape Wrench provided. using the
L Shape Wrench provided.
B. TIP: Start with the right side of the chair with
the recliner. lt is much easier to start on this
side as the mount point is fixed in place. Do
not tighten the screws down completely until
you have both sides (all four bolts) started in
the seat back.
C. Use the screws taken from the seat back
to attach the seat cushion and the seat
back together.
5
6. Place seat assembly onto
the chair base assembly by
inserting the gas lift cylinder
into the center hole in the seat
mechanism.
A. It will slide into place. Make
sure the seat assembly is firmly
pressed down into place before
using the chair.
7. Tight the screw into the hole on the recliner
cover to attach the recliner cover, and then
attach the screw cover on it.
A. There is a right and left side cover.
The taller of the two covers is for
use over the side with the handle
for the recline function.
8. Enjoy your new FOCUSEAT
gaming chair.
6