Start The Machine; Stop The Machine; Led Light; Speed Selection - GreenWorks GD24ID3 Manuel Opérateur

4.1

START THE MACHINE

Figure 4.
The machine can not work until the reversing button is
pushed fully to the left or right. Do not operate the machine
at low speeds for extended periods of time.
1. Push the switch trigger to turn the machine ON (I).
4.2

STOP THE MACHINE

Figure 4.
1. Release the switch trigge to turn the machine OFF (O).
WARNING
Release the switch trigger and let the coupler to come to a
complete stop.
4.3

LED LIGHT

Figure 5.
The LED light illuminates when the trigger is depressed.
It provides extra light for increased visibility.
4.4

SPEED SELECTION

Push the button (1) to adjust the speed. The lights (2) will
illuminate according to the speed level.
Figure 6
Lights Speed level
3 Green Lights The machine is in "high speed" setting.
The machine is in "medium speed" set-
2 Green Lights
ting.
1 Green Light The machine is in "low speed" setting.
4.5 ADJUST THE TURNING
DIRECTION
Figure 7.
The machine has the reversing button (forward/reverse lock)
above the switch trigger to chang the direction of the bit.
1. When the reversing button is on the left side of the switch
trigger, the bit direciton is forward.
2. When the reversing button is on the right side of the
switch trigger, the bit direction is reversible.
3. Put the direction button in the OFF (center lock) position
to help decrease the possibility of accidental start when
not operate.
WARNING
Let the coupler to come to a complete stop before changing
the direction of rotation.
NOTE
English
4.6

OPERATE THE MACHINE

1. Put the lock-off button in the correct position for the
operation.
2. Hold the machine with one hand.
3. Put the bit on the screw head and slowly push the switch
trigger. Start the bit slowly for more control.
4. When you drive the screw, work will begin.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
6

TECHNICAL DATA

Voltage
No Load Speed
Impact rate
Torque
Weight without battery
Battery model
Charger model
Measured sound pressure
level
Measured sound power level 90.8 dB(A), K
5
CAUTION
CAUTION
WARNING
CAUTION
24 V
-1
0 - 2,800 min
-1
0 - 4,000 min
300 Nm
1.18 kg
G24B2 / G24B4 and other
BAG series
2913907 and other CAG ser-
ies
79.8 dB(A), K = 3 dB(A)
pA
= 3 dB(A)
wA
EN