Technical Specifications - Denver TCU-211 Manuel D'instructions

Symptoms
Noise or sound
distorted on FM
broadcast
Appliance does not
work.
Unable to play a CD
CD skips while
playing
Intermittent sound
from CD player
Appliance does not
react to pressed
buttons/keys
Appliance enters
STANDBY mode
after 10 minutes
(approx.)
Power supply:
Power consumption:
Standby consumption: 0.5W
Power Amps:
Max Output Power:
Frequency bands:
Batteries:
TROUBLESHOOTING
Possible cause
Station not tuned properly.
Telescopic antenna is not
fully extended
Power cable is not
connected properly.
Unit not in CD function
mode.
CD is installed incorrectly.
Disc is dirty or scratched.
Dirty or defective disc. Dirty
pick up lens.
Player is subject to
excessive shock or
vibration.
Malfunction due to
electrostatic discharge.
Power saving function
enabled

TECHNICAL SPECIFICATIONS

230V~ 50Hz
14W Max
2 x 1W
2 x 1.1W
FM 87.5 - 108 MHz
9V 6 x 1.5V "C" size/UM-2/LR14 (Optional, not supplied)
Solution
Fine tune the FM broadcast station. Fully
extend the FM telescopic antenna
Check if the power cable is properly
connected to the AC socket at the back of
the appliance and to an electrical outlet.
Select CD function mode.
Insert CD with label side up.
Wipe CD with clean cloth or use
another disc.
Clean or replace the defective disc. Use a
CD-lens cleaning disc to clean the lens.
Relocate the player away from shock
or vibration.
Disconnect the appliance from the power
supply.
Connect the power plug again to an
electrical outlet.
This is normal operation due to new ECO
regulation requirements this product
incorporates a power saving feature.
7
ENG