Power On/Stand-By; Operating Mode - DELTACALOR PIANO Notice D'utilisation Et D'installation

Power on/Stand-by

Press the ON/STAND-BY key to turn on the device or to enter the «Stand-by» mode.
When activated, the bottom part of the display shows the current time, while the configured ope-
rative mode and the temperature are shown in the upper part. When in «Stand-by» mode current
time, day of the week and the message: « Stb» are displayed.
NOTE: When the device goes into «Stand-by» mode it beeps twice for 0.5s.
When the device is activated it beeps once for 1s.
Example in «Comfort» mode Example in «Stand-by» mode.
COMFORT and NIGHT modes
Two different levels of temperature can be set:
-»COMFORT» temperature: It is the temperature used for «Chrono», «Fil-Pilote» and «Comfort»
modes.
-»NIGHT» temperature: It is the temperature used for the «Night» and «Chrono» modes.
The desired temperature can be set pressing the [+] e [-] buttons. The range of configurable
temperature is 7°C
- 32°C.
IMPORTANT!
The temperature of «Night» mode must be below to the "Comfort" mode temperature. For this
reason the "Night" mode temperature can be set to a value between 7°C and the (configured
«Comfort» mode temperature - 0.5°C).
The temperature of «Comfort» mode can be configured in the whole (Night temperature +
0.5°C) ÷ 32°C range.

Operating Mode

Press the PROG to select the desired operative mode. An icon on the display indicates the
selected operating mode, according to the following table:
Fil-Pilote Comfort Night Antifreeze Timer 2 h Chrono
Confort mode
The «Comfort» stably maintains the room temperature to a selected value. To set this operative
mode:
• Press the PROG button until the display shows the "Comfort" icon
• Set the desired temperature through [+] and [-] buttons.
[ 44 ]