Conrad ITC-BEL-1 Manuel D'utilisation page 2

ITC-BEL-1 : USER Manual
Thanks for choosing our digital counting sc ale which i s e a s y t o o p e r a t e . P l e a s e r e a d t h e u s e r m a n u a l
carefully before you use It.
O p e r a t i o n :
1 . Put 2xAAA battery into the battery room of the scale and place the scale on a solid and flat board without
wind and vibrancy.
2. Press the button ON/OFF" or "0.00" Is displayed in 3 seconds.
N
3..Put the article on the salver .The unit code Is twinkling when It has not be steady; you can read the weight
when the unit code stops winkling.
4. Press the button UNIT" to switch unit (g/oz/dwt/ct/tl/gn).
N
5. Press the button TARE" to force to the nullng operation.
N
6. Press the button PCS" to operate counting (see details)
N
How to operate Counting Function
Please prepare 25.50.75 or 100 pieces of samples. When the scale is ready to weight goods. place the
samples on the salver, then you can see the weight. Please press the button " PCS" tor 3 seconds, the screen
shows a quantity you can press the button "UNIT" to select a right quantty25-
button "PCS" for confirmation. At this time. the screen displays the quantity. You can press the button "PCS" to
come to weighing status, then you can weight more goods, Press the button "PCS" to read
quantity when you need.
Attention:
Place the scale on a solid and flat board without wind and vibrancy
Do not over load . Otherwise the sensor will be damaged
Do not bump the salver when you put the article on the salver, put If carefully.
Keep away from mobile phones over 50cm.
Read the weight after the unit code stop twInkIng.
Replace batteries when It shows low power.
Working temperature: 10-30°C. Please calibrate the
scale If the temperature Is too low/hIgh, Please place the scale In 30mlnutes first, let the temperate Is even,
then make the calibration.
The screen dIsplay "FULL" when It Is over weight.
Please do not disassemble! Careful storage!.
Specification parameter :
- Power Control : Auto power off after 1 minute
without operation(set up) - Switch on/off:
- Working temperature: 10-30'C
- Back light : white
- Power supply: Alkaline Battery AAAx2
- Measure: 116X64X17mm
- Weight : 95.6 g
- Salver Size: 62.2 x 53.7mm
- Tare Counting
50,75 or 100 pieces. finally, press the
1