Tool Components And Specifications - Campbell Hausfeld SN338K00 Mode D'emploi

Operating Instructions
Important Safety Instructions
(Continued)
OPERATOR'S RESPONSIBILITY:
The tool operator is responsible for:
• Reading and understanding tool
labels and manual.
• Selecting an appropriate tool
actuation system, taking into
consideration the work application
for which the tool is used.
• The safe use of the tool.
• Ensuring that the tool
is used only when
the operator and all
other personnel in the
work area are wearing ANSI Z87
eye protection equipment, and
when required, other appropriate
protection equipment such as
head, hearing and foot protection
equipment. Serious eye or
permanent hearing loss could result.
• Assuring that the tool is kept in safe
working order as described in this
manual.

Tool Components and Specifications

• REQUIRES: 0.3 SCFM with
10 fasteners per minute @ 90 psi
• AIR INLET: 1/4 inch NPT
• FASTENER SIZE RANGE:
1/2 inch to 1-1/4 inch
• MAGAZINE CAPACITY:
100 Nails per Load, 18 gauge
• STAPLES: 1/4 inch crown
• WEIGHT: 2 lbs. 13 oz.
• LENGTH: 9-1/2 inches
• HEIGHT: 8-3/4 inches
• MAXIMUM PRESSURE:
100 psi
• PRESSURE RANGE:
60 psi – 100 psi
www.chpower.com
EMPLOYER'S RESPONSIBILITY:
• Selecting an appropriate tool
actuation system, taking into
consideration the work application
for which the tool is used.
• Ensuring that this manual is
available to operators and personnel
performing maintenance.
• The safe use of the tool.
• Enforcing that the
tool is used only when
the operator and all
other personnel in the
work area are wearing ANSI Z87
eye protection equipment, and
when required, other appropriate
protection equipment such as
head, hearing and foot protection
equipment. Serious eye or
permanent hearing loss could result.
• Assuring that the tool is kept in safe
working order as described in this
manual.
• Assuring the proper maintenance of
all tools in employer's possession.
• Ensuring that tools which require
repair are not further used before
repair. Tags and physical segregation
are recommended means of control.
Adjustable
Depth Control
Work Contact
Element (WCE)
2
GENERAL
a. To reduce the risks of
electric shock, fire, and
injury to persons, read all
the instructions before
using the tool.
b. Be thoroughly familiar with the
controls and the proper use of the
equipment. Follow all instructions.
Contact your Husky representative if
you have any questions.
c. Only persons well acquainted with
these rules of safe operation should
be allowed to use the unit.
labels and manual. Failure to follow
warnings, dangers, and cautions could
result in DEATH or SERIOUS INJURY.
WORK AREA
a. Keep the work area clean and well
lighted. Cluttered benches and dark
areas increase the risks of electric
shock, fire, and injury to persons.
b. Do not operate the tool
in explosive atmospheres,
such as in the presence
of flammable liquids,
gases, or dust. The tool is
able to create sparks resulting in the
ignition of the dust or fumes.
c. Keep bystanders, children, and
visitors away while operating the
tool. Distractions are able to result in
the loss of control of the tool.
Cap Exhaust
Trigger
Warning
Label
Fastener Discharge Area
SN338K00
Read and
understand tool
Latch
Button
Magazine