resideo Q3200U Instructions D'installation

Q3200U/Q3205U
Universal Hot Surface Igniter Kit
1-23/64
(35)
1-25/32
(45)
2-13/16
(72)
15-45/64
(399)
GLOWFLY
®
APPLICATION
The Q3200U and Q3205U Universal Hot Surface igniter Kit is
designed to provide a robust field service replacement igniter
in gas fired appliances with Norton / St Gobain 12 Vac Silicon
Carbide Hot Surface Igniters. They use a 120 Volt Silicon
Nitride igniter designed with long life and high resistance to
damage or burn out in the appliance. The kit includes the
specially designed silicon nitride igniter and six different
bracket configurations to adapt the igniter to the specific
appliance application along with accessory parts to allow
mounting and wiring of the igniter. Clear instructions and
application templates are provided to simplify selection of
the proper bracket and ease installation of the replacement.
1-21/32
(42)
2-19/64
(58)
3-23/64
(85)
15-45/64
(399)
GLOWFLY ® PRO
M37744A
Fig. 1.
INSTALLATION INSTRUCTIONS
BEFORE YOU START
1. Review this instruction sheet fully to ensure you are
familiar with the steps and information necessary to
complete the installation properly, including the
WARNING section on this page.
2. Confirm the existing hot surface igniter has failed:
a. Run an appliance cycle and observe the installed
igniter.
b. If the igniter glows, the problem is not the igniter.
c. If the igniter does not glow during an ignition cycle:
(1) Unplug the igniter lead wires.
(2) Set a voltmeter's scale to 300 VAC and connect
the voltmeter to the igniter harness.
(3) Run another cycle and confirm 120 VAC power
at the harness during the igniter warm up time.
3. Check the appliance construction and wiring diagram
(typically located on an appliance panel) and confirm
that the appliance does not use the hot surface igniter
as the flame sensor. Do not use the Q3200 or Q3205 kit
if the existing igniter is also the flame sensor. Use an
original equipment part. The Q3200/Q3205 is not
designed to be used as a flame sensor.
4. If the appliance is a sealed combustion model,
determine if the existing hot surface igniter ceramic is
part of the sealing of the burner box. If it is, check
carefully to determine if this kit will allow the proper
appliance function.
5. Confirm the kit components:
a. six brackets stamped A, B, C, D, E, and F
b. one hot surface igniter with wiring leads
c. two wire nuts and a thread forming screw
6. The Q3200/Q3205 should not be handled by the black
silicon nitride igniter. Use care to handle the
Q3200/Q3205 by the ceramic casing or the bracket.
INSTALLATION
When Installing This Product...
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
2. Check the cross reference table on page 5 and the
templates (Fig. 2 on page 3 and Fig. 3 on page 4) to
make sure the proper igniter bracket is used for your
application.
69-2334EF-07