Operation Conditions - MW TOOLS TPSL 1000 Mode D'emploi

TOOLS
1 Safety
• This manual stacker can only be operated indoor on even and solid ground and it is strictly prohibited to operate the stacker in a
corrosive environment with acid and alkali.
• Please read this manual carefully and understand the performance of the stacker before operating. Inspection of the stacker should be
conducted carefully every time before operation to ensure that the stacker is in normal condition. It is strictly prohibited to operate a faulty
stacker.
• It is strictly prohibited to overload the stacker. The load capacity and the load center should meet the requirements in the parameter table
of this manual.
• When stacker is used for piling, the gravity center of the goods must be within the two forks and it is strictly prohibited to pile loose
goods.
• When it is required to transport the goods for a comparatively long distance, the height of the forks from the ground should not exceed
0.5 m.
• When piling goods, it is strictly prohibited for people to stand under the forks or around the stacker.
• It is strictly prohibited to stand on the forks for operation.
• When the goods are on high level, the goods should be pushed forward or pulled backward slowly and no cornering is allowed in such
a case.
2 Outline drawing and technical parameters
Model
Load capacity
Load center distance
Mast height
Maximum lifting height
Lowered fork height
Overall length
Overall width
Fork dimensions
Distance between fork-arm
Turning radius
Lifting speed
Lowering speed
Noise level
Weight
Exploded views and spare parts: pages 8 to 15

3 Operation conditions

• Working temperature: -25 to +40 °C.
• Relative humidity: < 90%.
• The stacker can only operate in an environment without rain and harmful gas erosion.
• The stacker can only operate indoor on even and solid ground.
4 Structural characteristics and working principle
This manual stacker consists of a hydraulic system, mast and forks.
The stacker uses a manual hydraulic pump (hydraulic device) as force to lift heavy goods, which are pushed, pulled and handled manually.
The hydraulic device is equipped with an oil return valve and the fork decline speed is controlled via a hand lever to make the operation of
the hydraulic system correct, safe and reliable. The mast is welded with high quality profile steel such as to good rigidity and high strength.
Universal wheels with braking device are adopted as the back wheels, which can rotate freely, easily and flexibly. Both front and back wheels
are installed on wheel shafts with ball bearings so as to rotate flexibly. Wear-resistant and durable nylon wheels are adopted so that it is not
easy to damage the operation ground.
TPSL 1000
kg 1000
c mm 600
h1 mm 2080
h3 mm 1600
h13 mm 90
l1 mm 1655
b1 mm 755
s/e/l mm 61 x 170 x 1100
b5 mm 550
Wa mm 1380
mm/times 25
mm/s. Controlled type
dB < 70
kg 210
I．Outline drawing and Key technical p
6
TPSL1000 - NLFREN - v1.1 - 07092017
EN
Model
Load capacity
Load center d
Service weigh
Height, mast
Max. lift heigh
Height, mast
Lowered fork
Overall length
Overall width
Fork dimensio
Distance betw
Turning radius
Lift speed, lad
Lowering spee
Noise level