Table des Matières
Publicité
To install bagger com po nents to tractor
1. Dis charge Chute
2. 3/8 Nut
3. Flat Washer
•
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
•
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
3
2
1
1. 3/8 Lock nut
2. Flat Wash er
3. Support Tube
•
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
1
2
3
1. Support Bracket
2. Clevis Pin 10 x 17mm
3. 3/8 Lock Nut
4. 3/8 x 63,5mm Hex Bolt
5. 10,3mm (13/32") flat
washer
6. Retainer Spring
•
Install the two upper support brack ets through the back
plate and to the chas sis, install the clevis pin 10x17mm
and secure with retainer spring.
•
Assemble both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 3/8 locknuts from parts
bag. Tight en securely.
1. Hook
2. Discharge Chute
3. Back plate slot
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to float with the
mower deck when moving on uneven terrain.
23
2
3
1
5
4
6
2
2
1
3
Publicité
Table des Matières
