Super Ego 186000000 Mode D'emploi page 23

Safety instructions
operations
Before using the metal-cutting saw:
WARNING: To avoid mistakes that could cause
serious, permanent injury, do not plug the saw
until the following steps have been satisfactorily
completed.
• Completely assemble and align saw. (see
"Assembly and Alignment" sections within).
• Learn the use and function of the ON-OFF
switch, upper and lower guards, look, pin and
workpiece clamp. (See "Geeting to know your
metal-cutting saw" section within).
• Review and understand all safety instructions
and operating procedures in this manual.
• Review the maintenance methods for this
Metal-cutting saw. (See "Maintenance section
within").
To avoid injury or death from electrical shock:
• Make sure your fingers do not touch the plug's
metal prongs when plugging or unplugging
the Metal-cutting saw.
Before each use:
Inspect your saw.
Disconnect the metal-cutting saw. To avoid injury
from accidental starting, unplug the saw, before
changing the setup, changing the blade or adjusting
anything.
Tighten the arbor screw.
Tighten the cover plate stop screw.
Check damaged parts. Check for:
• Alignment of moving parts,
• Damaged electric cords,
• Binding of moving parts,
• Stable mounting,
• Function of arm return spring and lower guard:
push the arm all the way down, then let it rise
up until it stops by itself. Check the lower guard
to see if it closed fully. If it did not, follow the
instructions in the troubleshooting section.
• Other conditions that may affect the way the
saw works.
If any parts of this saw is missing, bent, or broken in
any way, or any electrical parts don't work, turn the
saw off and unplug it.
Replace damaged, missing, or failed parts before
for basic saw
ENGLISH
using the saw again.
Keep guards in place, in working order, and in proper
adjustment.
Maintain tools with care. Keep the saw clean for
best and safest performance. Follow instructions for
lubricating.
Remove adjusting keys and wrenches from tool
before turning it on.
To avoid injury from jams, slips or thrown pieces:
• Use only recommended
"Accessory" section within.). Consult this
owner's manual for recommended accessories.
Follow the instructions that come with the
accessories. The use of improper accessories
may cause risk of injury to persons.
• Choose the right 14-inch (355 mm) diameter
cut-off wheel for the material and the type of
cutting you plan to do.
• Make sure the blade is undamaged and
properly aligned. With the saw unplugged,
push the power-head all the way down. Hand
spin the blade and check for clearance shown
in the maintaining maximum cutting capacity
section.
• Make sure the blade and arbor collars are
cean.
• Make sure the collars' recessed sides are facing
the blade.
• Using the arbor wrench supplied, make sure
the arbor screw es firmly hand tightened.
• Make sure all clamps are right and there is no
excessive play in any parts.
• Keep work area clean. Cluttered areas and
benches invite accidents. Floor must not be
slippery.
• Know your saw. Read and understand the
ower's manual and labels affixed to the tool.
Learn its application and limitations as the
specific potential hazards peculiar to this tool.
To avoid injury from accidental contact with moving
parts, don't do layout, assembly, or setup work on
the saw while any parts are moving.
Avoid accidental starting. Make sure switch is "OFF"
before plugging metal- cutting saw into a power
outlet.
accessories. (See
23