Hearing Safety - Philips AZ1840 Manuel D'utilisation

– Le périphérique n'est pas connecté correctement au
port USB du AZ1840 .
• Connectez de nouveau le périphérique, et
assurez-vous que le périphérique est alimenté.
– Le périphérique n'est pas supporté par l' AZ1840 ,
ou le format du fichier audio stocké sur le
périphérique n'est pas supporté par l' AZ1840 .
• Utilisez un périphérique/format de fichier audio
compatible.

Hearing Safety

Listen at a moderate volume.
• Using headphones at a high volume can impair your hearing. This product can produce sounds in
decibel ranges that may cause hearing loss for a normal person, even for exposure less than a
minute. The higher decibel ranges are offered for those that may have already experienced some
hearing loss.
• Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of
sound. So after prolonged listening, what sounds "normal" can actually be loud and harmful to
your hearing. To guard against this, set your volume to a safe level before your hearing adapts and
leave it there.
To establish a safe volume level:
• Set your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and clearly, without distortion.
Listen for reasonable periods of time:
• Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss.
• Be sure to use your equipment reasonably and take appropriate breaks.
Be sure to observe the following guidelines when using your headphones.
• Listen at reasonable volumes for reasonable periods of time.
• Be careful not to adjust the volume as your hearing adapts.
• Do not turn up the volume so high that you can't hear what's around you.
• You should use caution or temporarily discontinue use in potentially hazardous situations.
• Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.; it may
create a traffic hazard and is illegal in many areas.
Impossible d'utiliser la télécommande
pour sélectionner les modes CD ou USB.
– L'unité principale n'est pas réglée sur le mode
CD/USB.
• Sur l'unité principale, réglez le sélecteur de source
en position CD/USB, puis utilisez la télécom-
mande pour sélectionner CD ou USB.