Worx MAKERX Mode D'emploi page 14

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Press and hold the spindle lock button. Loosen the chuck first to insert the
accessory into the collet. Then use the spanner to tighten. (See Fig. A1, A2, A3, A4, A5)
More information about accessories, please check the table below.
NOTE: Before changing the accessories, make sure your machine is turned off and
disconnected from the hub.
WARNING:
operating speed setting of the tool.
2. Connect the rotary tool to the hub . (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the"Min" position. (See Fig. C)
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip. Press
EN the on/off switch on the hub to start the machine. (See Fig. D)
NOTE: Always start at no load to achieve maximum speed then start working. Do
14
not use excessive contact pressure! A correct and uniform speed enables better
performance.
2. Adjust speed as needed. (See Fig. E)
3. Press the on/off switch on the hub to turn off after use.
NOTE: For sake of safety, disconnect from the hub and adjust the speed control
button to "Min" position once completing the operation.
MAINTENANCE
Remove the battery pack from the machine before carrying out any
adjustment, servicing or maintenance.
Please do not disassemble the machine by yourself, contact service agent for
maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
To reduce the risk of injury, use only accessories rated for the