Making Preparations - Rothenberger FF35026 Instructions D'utilisation

Assembly and checks
Assembly:
Screw the hose (3) into the tank (1).
Checks:
Visual inspection: Are tank (1), pump (2) and hose (3) undamaged?
Pay special attention to the connections between the tank – hose and to the condition of the pump
thread and hose.
No leaks: Pump up the empty device to 2 bar.
The pressure must not decrease more than 0.5 bar within 30 minutes.
Function: Pull the red button on the safety valve (4).
The pressure must dissipate.
Making preparations and use
Observe the instructions in the section entitled "Safety"!

Making preparations:

1. Pull up the red button on the safety valve (4) until all excess pressure is released from the tank.
2. Press the pump handle (2) down and turn it counterclockwise.
 The pump handle is locked in place.
3. Unscrew the pump (2) from the tank (1).
4. Add the liquid to the tank (1).
All excess pressure must be released from the device.
5. Screw the pump (2) into the tank (1).
6. Press the pump handle (2) down and turn it clockwise.
 The pump handle is unlocked.
7. Generate pressure (approx. 2 bar) in the tank (1).
The maximum pressure should not exceed 6 bar. If the maximum pressure is exceeded, the
safety valve will engage and release the excess pressure.
8. Press the pump handle (2) down and turn it counterclockwise.
 The pump handle is locked in place.
Use:
1. Connect the plug-in coupling of the water pressure tank to the plug-in nipple on your device.
2. Activate the ball valve on your device.
 The liquid starts to be supplied.
The amount of liquid can be regulated via the ball valve on the device (e.g. drill).
3. If the pressure drops below 1 bar (min. 0.5 bar), pump again.
4. If the tank is empty, refill (see chapter "Preparation").
6
ENGLISH