Installation Limitations; Door Alignment; Reversing The Door - Uberhaus BCD-88 Mode D'emploi

English

Installation Limitations

Do not install your refrigerator in any location not properly insulated or
e.g. garage, etc. Your refrigerator was not designed to operate in
settings below
Select a suitable location for the refrigerator on a hard even surface
from direct sunlight or heat source, e.g. radiators, baseboard heaters,
appliances, etc. Any floor unevenness should be corrected with the leveling
located on the front bottom corners of the refrigerator.

Door Alignment

Freezer Door: (see fig. #1)
Remove the top hinge cover.
Loosen the top hinge screws using a Phillips head screwdriver.
Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover.
Reversing the Door (See Fig. #4)
Remove the top hinge cover.
Using Phillips
screws holding the top hinge in place.
Remove top hinge and carefully lift off
freezer door.
Remove the screw hole plugs from
opposite side and insert the plugs in
screw hole openings of the just
screws.
Open refrigerator door and unscrew
while holding the open door in place.
Remove bracket and lift off refrigerator door
While doors are removed unscrew the door stoppers and reinsert on
side of door.
Remove the screw hole plugs from the opposite side and insert the plugs in
screw hole openings of the just removed
Remove any loose items in the refrigerator
carefully tilt refrigerator and lean against
Remove both leveling legs and place in a
area.
Loosen the screws holding the lower hinge
to the refrigerator door and remove screws
bracket. Remove leveling leg.
5
Fig.
loosen and remove
screws from the center hinge
Fig.
Fig.