Télécharger Imprimer la page
Honeywell 50050477-001 Guide Du Propriétaire
Honeywell 50050477-001 Guide Du Propriétaire

Honeywell 50050477-001 Guide Du Propriétaire

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

20/40/60 Minute Timer
PART #50050477-001
OPERATING YOUR 20/40/60
MINUTE FAN TIMER
Press and release the Select Button to activate a 20, 40
or 60 minute high speed override cycle. The High Speed
Status Light will illuminate, and the unit will run on high
speed ventilation for the selected time. The High Speed
Status Light will dim after 10 seconds of run time. The
High Speed Status Light will flash during the last 5
minutes of the cycle. All timers connected to the unit will
illuminate for the duration of the override when the Select
Button is pressed.
Lockout Mode
Lockout Mode can be useful if you wish to disable the
timers. The timer can be set to lockout mode by pressing
and holding the Select Button for 5 seconds. After 5
seconds, the High Speed Status Light will flash; release
the Select Button. The timer is now in lockout mode. If
the Select Button is pressed, during the lockout mode,
the High Speed Status Light will monentarily illuminate,
but no override will be initiated.
If lockout mode is initiated when the timer is activated,
the timer will continue its timed sequence, but will not
allow any further overrides to be initiated. Lockout mode
can be unlocked by pressing and holding the Select
Button for 5 seconds. After 5 seconds, the High Speed
Status Light will stop flashing. Release the Select Button,
and the timer will now operate normally.
Easy to install
The 20/40/60 Minute Timer mounts in a 2" X 4"
electrical box.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
customer.honeywell.com
Terminal Block
— Wire multiple timers individually to the unit
— Use 3/20 low voltage wire
WARNING
It is recommended to wire multiple timers
individually back to the unit. Troubleshooting
for a broken wire will be difficult if multiple
timers are connected in series.
From timer to terminal block:
Yellow on timer to YELLOW #4
Red on timer to RED #3
Green on timer to GREEN #5
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
69-2417EF—01
E.K. Rev.02-10
Printed in U.S.A.
OWNER'S GUIDE
YEL
RED
GRN
Fig. 1. Terminal Block Connections
1
6
2
7
3
8
4
9
5
10
M29838A
69-2417EF-01

Publicité

loading

Sommaire des Matières pour Honeywell 50050477-001

  • Page 1 Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 Honeywell Limited-Honeywell Limitée 35 Dynamic Drive ® U.S. Registered Trademark Toronto, Ontario M1V 4Z9 © 2010 Honeywell International Inc. 69-2417EF—01 E.K. Rev.02-10 customer.honeywell.com 69-2417EF-01 Printed in U.S.A.
  • Page 2 Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 Honeywell Limited-Honeywell Limitée ® Marque de commerce déposée aux É.-U. 35 Dynamic Drive © 2010 Honeywell International Inc. Toronto, Ontario M1V 4Z9 Tous droits réservés 69-2417EF—01 E.K. Rev. 02-10 customer.honeywell.com 69-2417EF-01 Imprimé...