Safety Precautions; Grounding Instructions - Clarke BextSpot Pro Spotter 130SP Mode D'emploi

SAFETY PRECAUTIONS

This machine is intended for commercial use. It is constructed for use in an indoor environment and is not intended for any other use. Use only
recommended accessories.
All operators shall read, understand and exercise the following safety precautions:
1) Do not operate machine:
• Unless trained and authorized.
• Unless you have read and understand operators manual.
• In fl ammable or explosive areas.
• With damaged cord or plug.
• If not in proper operating condition.
• In outdoor areas.
• In standing water.
• Without Filters in place.
• With the use of unapproved extension cords.
2) Before operating machine:
• Make sure all safety devices are in place and operate properly.
3) When using machine:
• Mix and handle any chemicals according to manufacturer's recommendations.
• Do not run machine over cord.
• Do not pull machine by cord or plug.
• Do not pull cord around sharp edges or corners.
• Do not unplug by pulling on the cord.
• Do not stretch cord.
• Do not handle plug with wet hands.
• Keep cord away from heated surfaces.
• Do not pick up fl ammable materials or reactive metals.
• Report machine damage or faulty operation immediately.
4) Before leaving or servicing machine:
• Turn off machine.
• Unplug cord from outlet.
5) When servicing machine:
• An experienced technician should only perform service work.
• Unplug cord from outlet.
• Use manufacturer supplied or approved replacement parts.
• Avoid moving parts. Don't wear loose clothing.

GROUNDING INSTRUCTIONS

General – This carpet spotting machine shall be grounded while in use to protect the operator from electric shock. The machine is provided with
a three-contact grounding type attachment plug to fi t the proper grounding type receptacle. The green (or green & yellow) conductor in the cord is
the grounding wire. Never connect this wire to other than the grounding pin of the attachment plug.
This machine is for use on a nominal 120-volt circuit and has a grounding plug that resembles the plug illustrated in fi gure below. Make sure that
the machine is connected to an outlet having the same confi guration as the plug. No adapter should be used with this machine.
2/14
INSTRUCTIONS FOR USE
Grounding Pin
FIGURE 1
Adapte
Metal Scre
Grounded Outlet
Grounded Outlet Box
56091115 - BextSpot Pro
ENGLISH - A
A - 3