Publicité
PRODUCT PRESENTATION
Monitored
Mortice
High Corrosion resistance
Delivered with armature
No mechanical wear
Ease of installation
Recommended for interior use
Fail safe (Door unlocked when power off)
Holding force: 300 kg
No residual magnetism
Built-in varistor: Built-in electronic protection
to eliminate back EMF
Dimensions (L x W x D): 228 x 38 x 27mm
Armature dimensions (L x W x D): 185 x 38 x 11mm
Power supply: 12/24V dc
Power absorption: 12 V dc = 510mA
24 V dc = 270mA
WEEE & RoHS
EC certification
IP42
PACKAGE CONTENTS
Armature
Magnetic lock
plate
1
1
M8x35
M8x25
screw
screw
1
1
ELECTRICAL CONNECTIONS
12V dc default setup
Terminal
Correspondence
block
+
12 or 24V dc
-
- 0 V
NC
Normally closed
C
COM
NO
Normally open
The N.O./N.C. signal only switches when the door is
closed and the electromagnetic lock powered.
IMPORTANT NOTE
Check the jumper position before connecting the
lock to the input current. A wrong position could
damage the lock. This type of damage is not
covered by the warranty.
All the information contained within this document (photos, drawing, features, specifications and dimensions) could be perceptibly different and can be changed without prior notice.
V3ER
300 Kg Mortice Electromagnetic lock
(For general use - not fire safety use)
Roll pin
M5x8
5x16
screw
washer
2
8
Joggle
Cap nut
Manual
bracket
1
2
Voltage selection jumpers
12V dc
Recommended power supplies
ADC335
Armature plate
Steel washer
Armature plate support
AMCCHANFR20 or
AMCCHANFR16
(Optional)
Rubber washer
Steel
Rubber
washer
2
1
1
24V dc
BS60
G0301FR1026V01
Roll pin
Screw
Screw
MOUNTING RECOMMENDATIONS
Armature plate
- It is vital to fix the electromagnetic lock and
armature plate solidly on their supports.
- Make sure that the magnet and the armature
meet evenly over their entire mating surfaces.
- The armature plate must be able to pivot slightly
about its center mounting screw to compensate
for any door misalignment.
OPTIONAL ACCESSORIES
References
Description
EN
Armature screw
Screw
Joggle
bracket
Joggle
bracket
Screw
AMCCHANFR16
AMCCHANFR20
Armature
mounting plate
Publicité
