Using Your Splitter; Selecting A Monitor Using Direct-Access Monitor Selectors; Resetting Your Splitter; Faqs - Belkin OmniView ExpandView Serie Manuel De L'utilisateur

Using your Splitter

Selecting a Monitor Using Direct-Access Monitor Selectors

Located conveniently on the front panel of the Splitter, direct-access
monitor selectors allow for simple, manual monitor selection. Each button
controls a monitor.
You can directly select which monitor you wish to access by pressing the
corresponding direct-access monitor selector next to the appropriate port.
The LED will be lit to indicate that the port is currently selected.

Resetting your Splitter

The reset button allows you to quickly and easily reset the Splitter. Simply
push the button and all of your monitors are reset and activated.
10-11
10

FAQs

Q:
How many Splitters can I daisy chain?
A:
You can daisy chain up to four Splitters.
Q:
How far can I connect my monitors from the Splitter?
A:
You can connect your monitors 30 feet away from the Splitter
without experiencing any degradation. Lower video resolutions are
recommended for distances beyond 30 feet.
Q:
Can I daisy-chain an F1DV104 with an F1DV108?
A:
Yes, you can daisy-chain the F1DV104 with the F1DV108.
Note: Make sure the F1DV108 is
the primary splitter when daisy-chaining.
Q:
Does the Splitter support DVI adapters?
A:
No, the Splitter does not support DVI-to-VGA adapters.
Q:
Does it require a power supply?
A:
Yes, the Splitter requires a 9V DC, 1.5A power supply.
11
15/11/04 3:03:04 pm