About Batteries - INFOSEC UPS SYSTEM Z3 Zenergy BOX 500 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The UPS has been designed for personal computers. It should not be used with
electrical or electronic equipment with inductive loads such as motors or fluorescent
lights.
Do not connect any household appliances such as microwaves, vacuum cleaners,
hair dryers or life-support systems to the UPS.
Due to excessive consumption, laser printers should not be connected to the UPS.
Please replace the fuse only with the same type and amperage in order to avoid fire
hazards.
o Good disposals of the device:
The mains outlet that supplies the UPS shall be located near the UPS and shall be
easily accessible.
Install the UPS in a temperature and humidity-controlled indoor area free of
conductive interference.
It should not be exposed to direct sunlight or sources of heat. Do not cover the
ventilation slots.
Disconnect the UPS from AC power before cleaning with a damp cloth (no cleaning
products).
Do not leave any recipients containing liquid on or near the UPS.
 About batteries:
It is recommended that a qualified technician change the battery.
Do not dispose of the battery in a fire as it may explode.
Do not open or damage the battery. Released electrolyte can be toxic and harmful
to the skin and eyes. In case of eyes or skin contact, wash it immediately with water.
The UPS contains one or two large-capacity batteries. To avoid any danger of
electric shock do not open it/them. If a battery needs servicing or has to be replaced,
please contact the distributor.
Servicing should be performed or supervised by competent personnel who take the
necessary precautions. Keep unauthorized personnel away from batteries.
A battery can present a risk of electric shock and cause short circuits. The following
precautions should be observed by the qualified technician:
Remove watches, rings or other metal objects from hands.
Use tools with insulated handles.
Disconnect the charging source prior to connecting or disconnecting
battery terminals.
When replacing batteries, use the same type and number of sealed lead-
acid batteries.
4 . S T O R A G E I N S T R U C T I O N S
The UPS should be stored with its battery fully charged. In the event of long-term storage,
the batteries should be recharged once every 3 months for 24 hours (by plugging the UPS
into the mains power supply and switching "ON") to avoid any deterioration in battery
performance.
Do not keep or use the UPS in any of the following environments:
Any area with combustible gas, corrosive substance or heavy dust.
Areas with excessively high or low temperature (above 40°C or below 0°C)
and humidity of more than 90%.
Areas exposed to direct sunlight or near sources of heat.
Areas subject to major vibration.
Outside.
In the event of fire in the vicinity, please use dry-powder extinguishers. The use of liquid
extinguishers may present a danger of electric shock.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 12 10 AA 59 204 07
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z3 zenergy box 700Z3 zenergy box 1000

Table des Matières