Ferrari Teamtex Cosmo SP Luxe black Manuel page 16

1. Thread the lap section through the
guides located at the front of the base
(blue arrows)
2. Thread the diagonal strap through the
two upper guides located on the back
of the seat shell.
3. Tighten the seat belt by pulling first on
the lap section, then on the diagonal
one.
4. Check that there are no kinks or twists
in the seat belt. Lock the 2 sections of
the belt with the blue lock-off clip. The
lock-off should be positionned against
the buckle of the seat belt.Do not use
the red lock-off for the rearward facing
installation. Always keep the seat in the
most reclined position.
3 Forward facing (9-18kg)
1. Fully recline the seat. Pull lap and diag-
onal sections of the car seat belt until
fully extended and feed both through
the space between the shell and the
base. Fasten the seat belt.
2. Thread the lap section through the
guides located below the red lock-off
clips. Open the red lock-off clip next to
the buckle, then route the diagonal
section of the belt through the open
lock-off clip.
3. Push the child seat right down into the
car seat, and tighten both sections of
the seat belt by pulling the belt in the
direction shown.
4. Close the lock-off across the diagonal
belt. Check that there are no kinks or
twists in the seat belt.
II INSTALLING YOUR CHILD IN THE CAR
SEAT
4 Harness : the buckle
5 Adjusting the harness
1. Adjust the shoulder height of the har-
ness in one of the three positions, so
that the belts are always at the height
of your child's shoulders. (see para-
graph 6).
2. To tighten the harness : Pull gently on
the harness adjuster to take up any
slack in the harness.WARNING : a loose
harness is dangerous: it is recommend-
ed that there is just enough room to
insert two fingers between the shoulder
straps and the child's chest.
3. To loosen the harness : press on the tab
of the central adjuster while at the
same time pull on both shoulder straps
(Do not pull on the shoulder pads
which are fixed in length).
6 Adjusting the shoulder height
1. Fully recline the seat.
2. Loosen the harness in order to access
to the metal yoke.
3. Remove one of the shoulder straps
from the metal yoke.
4. Feed the shoulder strap that have
undone through the shoulder slot in the
back of the shell and the cover. It is not
necessary to feed the strap through
the shoulder pad.
5. Pull back the top part of the seat cover
and white liner
6. Release the metal keeper of the shoul-
der restraint by feeding it back through
the slot, and through the liner and
cover.
7. Re-assemble the harness by threading
the keeper of the shoulder restraint
15