Electrical Connections - Kichler Motu 330010 Manuel D'instructions

6. INSTALLATION OF SAFETY SUPPORT
(Required for Canadian installation ONLY)
A safety support cable is provided to help prevent the
ceiling fan from falling, please install it as follows.
Step 1. Attach the provided wood screw and washers
to the ceiling joist next to the mounting bracket but do
not tighten. (Fig. 12)
Step 2. Adjust the length of the safety cable to reach
the screw and washers by pulling the extra cable
through the cable clamp until the overall length is
correct, put the end of the cable back through the cable
clamp, forming a loop at the end of the cable. Tighten
the cable clamp securely. Now, put the loop in the end
of the safety cable over the wood screw securely.
NOTE
: Although the safety support cable is required
for Canadian installations only. It's a good idea to make
the attachment with any installation.

7. ELECTRICAL CONNECTIONS

WARNING:
To avoid possible electrical shock, be sure
you have turned off the power at the main circuit panel.
Follow the steps below to connect the fan to your
household wiring. Use the wire connecting nuts
supplied with your fan. Secure the connectors with
electrical tape. Make sure there are no loose wire
strands or connections.
Step 1. Connect the fan supply wire (black) to the black
household supply wire. (Fig. 13)
Step 2. Connect the neutral fan supply wire (white) to
the neutral household wire (white).
Step 3. Connect the fan ground wire (green) to the
household ground wire.
Step 4. After connecting the wires, spread them apart
so that the green and white wires are on one side of the
outlet box and the black wires are on the other side.
Step 5. Turn the connecting nuts upward and push the
wiring into the outlet box.
60" Motu
Hanger bracket
Safety cable
Fig. 12
Outlet box
Black (hot)
White (neutral)
Black (motor)
Fig. 13
™
6
Attach safety cable
to ceiling joist with
screw and washer
White (neutral)
Ground
(Connect to
(green)
ground wire on
hanger bracket
if no house
ground wire
exists.)