Brandson Equipment 304287/20200108NB131 Mode D'emploi page 17

7. Single measurement / Continuous measurement
Single measurement
Press the "ON / OFF" button ( ) briefly in the start condition to switch on the
laser and to aim the laser beam on the object to be measured. Press again briefly
to run the single measurement, and the measurement result is immediately
displayed on the screen.
Continuous measurement
Press and hold the "ON/OFF button" ( ) for about 2 seconds in standby
mode. The continuous measurement begins.
8. Selecting the unit
The default measurement unit of the instrument is meter (m). Press and hold the
"Unit change / reference point change" button ( ) for some time to change
the measurement unit.
9. Measurement functions
Area measurement
Volume measurement
Pythagorean measurement I
Pythagorean measurement II
(plus)
Pythagorean measurement III
(minus)
17
English