HeatLink 46443 Mode D'emploi

#46443 User Guide
HeatLink Electronic Thermostat
®
Modes Description
• Electronic thermostat with night setback mode for hydronic floor heating systems
controlled by actuators.
• External pilot wire for night setback, equipped with a switch to select heating,
manual setback or timer setback mode.
• Regulating on internal sensor.
• Option: Possibility to regulate with an external sensor (NTC 10K)
The external sensor must be connected without a power supply. At power up
the thermostat automatically detects the sensor used. (If the external sensor is
connected the thermostat will use this sensor)
• Silent (triac output), to be connected directly to actuators (see connecting drawing
on the installation sheet) or to the StatLink
StatLink module datasheet)
®
L646443 - September 14, 2006
HeatLink and StatLink are registered trademark of HeatLink Group Inc.
Optional external sensor
(sold separately)
® system. (In this case please refer to the
Screw connector for power supply,
output and clock (pilot wire)
LED Indicator
Green:
Heating indication with internal sensor regulation
Green blinking: Heating indication with external sensor regulation
Orange: Reduction mode by clock (pilot wire)
Red: internal sensor failure
Red blinking: external sensor failure
Technical Characteristics
Measured temperature precision
Operating temperature
Setting temperature range
Regulation characteristics
Electrical protection
Power supply
Output
Optional external floor sensor
LED Indicator
Select mode
Room setting
Screw connector for internal
or external sensor
0.1°C (or 0.2°F)
0°C - 50°C (or 32°F – 122°F)
5°C - 30°C
(or 41°F - 86°F)
Static differential 0.5°K
Class II - IP30
24 VAC +/- 10%
TRIAC output 24 VAC, 15 W max.
( 4 actuators)
NTC (10K Ohms)