Matco Tools MWLALUM Instructions De Fonctionnement page 5

FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
SAVE THESE INSTRUCTIONS!
SAFETY INSTRUCTIONS FOR BATTERY CHARGER
AND BATTERY PACK
DANGER! READ CAREFULLY
120 Volts present at charging terminal.
Absolutely DO NOT probe with conductive
objects.
1. CAREFULLY READ AND UNDERSTAND THESE
INSTRUCTIONS
This manual contains critical safety and
operating instructions for the light, battery
charger, and battery.
2. Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery, and
(3) product using battery.
3. CAUTION - To reduce risk of injury, charge
only MATCO rechargeable batteries marked on
the charger label. Other types of batteries may
burst causing personal injury and
damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold
by Matco or the battery charger manufacturer
may result in a risk of fire, electric shock, or
injury to persons.
6. To reduce risk of damage to electric plug
and cord, pull by plug rather than cord when
disconnecting charger.
7. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress.
8. An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric
shock. If extension cord must be used, make
sure:
a. That pins on plug of extension cord are the
same number size, and shape as those of
plug on charger;
b. That extension cord is properly wired and in
good electrical condition;
c. That wire size is at least as large as the one
specified in the table below.
MWLALUM, MWLALUMG, MWLALUMO
350LM ALL ALUMINUM WORKLIGHT
WARNING
Table 1: RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
Length of Cord (Feet)
AWG Size of Cord
9. Do not operate charger with damaged cord or
plug - replace them immediately.
10. Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in
any way; take it to a MATCO AUTHORIZED
service facility.
11. Do not disassemble charger or battery cartridge;
take it to your MATCO AUTHORIZED distributor
service facility. Incorrect reassembly may result
in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk.
13. The battery charger is not intended for use by
young children or infirm persons without
supervision.
14. Young children should be supervised to ensure
that they do not play with the battery charger.
OPERATIONAL GUIDELINES FOR BATTERY
CHARGER AND BATTERY PACK
1. Do not attempt to use a step-up transformer, an
engine generator or DC power receptacle.
2. Do not allow anything to cover or clog the
charger vents.
3. Always cover the battery terminals with the box
or cover when the battery cartridge is not used.
4. Do not short the battery cartridge:
a. Do not touch the terminals with any
conductive material.
b. Avoid storing battery cartridge in a container
with other metal objects such as nails,
screws, coins, etc.
c. Do not expose battery cartridge to water or
rain. A battery short can cause a large
current flow, overheating, possible burns
and even a breakdown.
5. Do not store the light and Battery Cartridge
in locations where the temperature may reach
or exceed 50°C (122°F).
6. Do not incinerate the Battery Pack even if it is
severely damaged or is completely worn out.
5
25 50 75 100 150
18 18 16 14
07/06/18
12