neofeu NUSL1ECO Mode D'emploi page 7

anchor point must be located at the waist or above. This lanyard
must be kept taut and the free travel must be limited to a
maximum of 0,6 metres.
- The tool-holder rings must not be used as anchor points or
work positioning points under any circumstances.
- After a fall, the harness must be destroyed.
- The use of the belt fitted with connectors with screw gate
locking is accepted only if the user does not have to lock or
open the connector too frequently that is to say several times
on the same working day. If this is the case, it will be better to
use a connector with an automatic locking.
- A connector must never have a load on its clasp.
GENERAL CONDITIONS
HARNESSES AND WORK RESTRAINT BELTS :
- A periodic inspection carried out by a competent inspector is
necessary to ensure the safety of the user, which is connected
to the maintenance of the effectiveness and resistance of the
equipment. A mandatory annual inspection will check the
condition of the equipment and it can only continue to be used
on obtaining a written agreement.
- Do not expose these products to temperatures less than -30°C
or more than 50°C.
- This equipment must not be used in any way contrary to these
specifications and under no circumstances should its limits be
exceeded.
INTERPRETATION OF THE MARKINGS (#5):
- 1 Product Name (Model).
- 2 Pictogram requiring that the instructions be read before use.
- 3 Pictogram of the size and maximum safe working load of
the harness and the integrated belt (For ref NUSL4ECO).
- 4 Individual Production No.
- 5 Date of manufacture.
- 6 Expiry date.
These products comply with the 2016/425 Regulation They meet the requirements of the harmonised standards EN361:
2002 and EN358: 1999 for the NUSL4ECO reference. The declarations of conformity are available on: www.neofeu.com.
Notified body for UE type examination :
APAVE SUD EUROPE SAS (N°0082) – CS 60193 – F13322 MARSEILLE CEDEX 16
Notified body for production control :
AFNOR CERTIFICATION (N°0333) - 11, rue Francis de Pressensé - FR 93571 LA PLAINE SAINT DENIS Cedex
DE
STÜCKLISTE (#1A-1B-1C):
1- Feste Tragegurte
2 - Beingurte
3 - Flache Verschlussschnallen (#4).
4 - Schlinge.
5 - Befestigungspunkt im Brustbereich (A/2).
6 - Rückenöse zum Einhängen (A).
7 - Verlängerungsgurt (A).
8 - Rückenverstärkung.
9 - Gurtverstellband.
10 - Flache Gurtverschlussschnallen (#4).
11 - Einrastzapfen für Halt bei der Arbeit.
OF USE OF THE
- Storage: the product must be stored in a dry and well-
ventilated area, sheltered from any direct or indirect source of
heat and from ultra-violet rays. Drying wet equipment must be
performed in the same conditions.
- Cleaning and disinfection: exclusively with water and a neutral
soap.
- Packaging: use rot-proof and watertight protective packaging.
- Transport: packaged and sheltered from impacts or pressure
caused by the environment.
- The product must not be modified or repaired.
- Service life: Fall-protection PPE are designed to last for
several years in normal conditions of use and preservation.
The service life depends on the use. Certain environments
that are particularly aggressive, marine, siliceous or chemical
can reduce the service life of PPE. In these cases, special care
must be taken regarding protection and the inspections before
use. The mandatory annual inspection will validate the correct
functioning of the mechanism and it can only continue to be
used on obtaining a written agreement from the manufacturer
or its representative.
As concerns what has been mentioned above, the rough
estimate of the service life of the products, as recommended
by the marketing authority, is 10 (ten) years.
- Ensure that the identification sheet and the maintenance
monitoring table is kept up to date from the time of the
commissioning and during each inspection.
- 7 Reference standard and year of issue.
- 8 Manufacturer's logo.
- 9 Address of the Marketing Authority.
- 10 Identification of the notified body that intervened in the
inspection and production phase.
- 11 CE Marking.
12 - Materialträgerzapfen aus Kunststoff.
HINWEISE :
- Lesen Sie vor jeglicher Nutzung des Produkts aufmerksam
diese Gebrauchsanleitung durch, und bewahren Sie sie
sorgfältig auf.
- Beim möglichen Weiterverkauf dieses Produkts außerhalb
des ersten Bestimmungslandes hat der Einzelhändler diese
Bedienungsanleitung zur Verfügung zu stellen, die in der
Sprache des Landes der Nutzung dieses Produkts abgefasst ist.
- Arbeiten in großer Höhe sind riskant, und nur eine Person
in perfektem Gesundheitszustand und mit guter körperlicher
DEX HARECO-01-M-Ind 06 p 7 /32