Publicité
Operating Instructions
longer than 50 feet should have a 1/2"
I.D.
Liquid flow
control valve
Spray
nozzle
Trigger
1/4" NPT Male
air inlet
Figure 1 - Cleaning gun features
Troubleshooting Chart
Symptom
Possible Cause(s)
Tool not
1. Solution build up.
siphoning
solution
2. Corrosion.
properly
3. Low air pressure.
4. Air hose leaks.
5. Pressure drops.
6. Liquid flow control
valve shut-off.
Limited Warranty
This JobMate product carries a one (1) year warranty against defects in workmanship and materials. Trileaf Distribution
agrees to replace the defective product free of charge with the same model or one of equal value or specification, within
the stated warranty period, when returned by the original purchaser with proof of purchase. This product is not guaran-
teed against wear or breakage due to misuse and/or abuse.
This product is not guaranteed if used for industrial or commercial purposes.
Operation
NOTE: The use of a lubricator is NOT
recommended.
WARNING
!
exposure to vibration, work in awk-
ward positions and repetitive work
motions can cause injury to hands and
Barb
arms. Stop using any tool if discomfort,
fitting
numbness, tingling or pain occur, and
consult a physician.
1. Connect the solution hose to the
barb fitting.
2. Place material strainer end of hose
into the solution being sprayed.
3. Connect to air supply.
4. Pull the trigger and allow approxi-
mately 5 seconds for the solution to
Corrective Action
1. Remove by flushing with warm water.
2. Disconnect hose from tool and add two drops of mineral spirits through the
barb fitting on the tool after each use (see Figure 1).
3. Adjust the compressor regulator to tool maximum (90 psi) while the tool is
blowing air.
4. Tighten and seal hose fittings if leaks are found.
5a. Be sure the hose is the proper size. Long hoses or tools using large volumes of
air may require a hose with an I.D. of 1/2" or larger depending on the total
length of the hose.
5b. Do not use a multiple number of hoses connected together with quick connect
fittings. This causes additional pressure drops and reduces the tool power. Di-
rectly connect the hoses together.
6. Adjust liquid flow control valve to desired flow.
5. Adjust liquid flow control valve to
Do not misuse this
STORAGE
product. Excessive
The cleaning gun must be thoroughly
flushed with water before storing.
TECHNICAL SERVICE
For information regarding the opera-
tion or repair of this product, please
call 1-866-220-2097.
2
58-8410-0
reach the spray nozzle. Release the
trigger to stop the flow.
obtain desired solution flow.
Publicité
