Dell W2306C Manuel Du Propriétaire page 32

Problem
Poor picture quality when using a
device connected to the ANT/Cable
(coaxial) connector
Nothing appears on my LCD TV
display
32
Troubleshooting Your LCD TV Display
Possible Solution
Ensure LCD TV display is selected as the input source in the
1
Input Select menu. See "Input Select Menu" on page 24 for
more information.
Press Menu on the remote control, select Setup, and then select
2
Channel Setup. This resets the channels on your remote.
Check the aspect ratio settings in the TV Menu. Press the Menu
3
button on the remote control and select Size. For more
information on using the TV Menu, see "Using the TV Menu"
on page 23.
Reset the original factory defaults. Press Menu on the remote
4
control, select Setup, and then select Factory Reset.
Adjust the color temperature. Press Menu on the remote
5
control, select Picture, and then select Color Temperature.
The problem may be with your device, contact your service
6
provider.
Ensure the LCD TV display is turned on.
1
Verify that all the cables are properly connected to the LCD TV
2
display, including the power cable.
Check to see if there is a blue or amber light on the lower,
3
right-hand corner of the LCD TV display. A blue light indicates
the LCD TV display is on. An amber light means the LCD TV
display is in power save mode.
Ensure the proper source is selected in the Input Select menu.
4
See "Input Select Menu" on page 24 for more information.
Reconnect any devices that are currently connected to the LCD
5
TV display. If you are using multiple devices, connect and test
one device at a time.
Connect another device that you know is working properly.
6
Reset the original factory defaults. Press Menu on the remote
7
control, select Setup, and then select Factory Reset.