Before First Use - Vollrath JT4 Manuel D'utilisation

FEATURES
F
G
H
F
E
G
D
C
B
Controls
bottom
conveyor
Back View
A Collection Pan
B Power Knob
Full Power - maximum heat
Off
Standby - reduces electrical consumption by 75%.
C Bottom Heat Control Knob
D Top Heat Control Knob
E Conveyor Speed Control Knob
F Conveyor
G Crumb Tray
H Adjustable Heat Shield
I Reset Button (Reference only. Access is via the front of the
toasters. See page 3.)

BEFORE FIRST USE

1. Clean the toaster. See "Daily Cleaning" on page 3.
2
A
Controls
top
conveyor
I
Dual Conveyor Toasters, Up To 1,100 Slices (Combined) Per Hour* Operator's Manual – Model JT4
OPERATION
CAUTION
H
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
NOTICE: The crumb trays must be installed in the toaster during
operation. Failure to install the crumb trays will cause the
toaster to overheat.
NOTICE: Do not toast buttered bread or coated bread products such
as pastries. This will damage the equipment.
Adjust the Heat Shield
E
Excess space above the product will create heat loss and may reduce
D
performance.
C
1. When the equipment is cool to the touch, use a screwdriver to
loosen the screw on the heat shield.
B
2. Grasp the shield and pull it up or down to adjust the opening so the
tallest products can pass through. Re-tighten the screw.
Preheat
Preheat one or both chambers based upon need. The knobs on the left
control the top chamber; knobs on the right control the bottom
chamber.
1. Plug the toaster into a grounded electrical outlet that matches the
rating on the name plate found on the side of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Rotate the power knob to the full power position (I).
3. Set the conveyor speed control knob to 7.
4. Rotate the top and bottom heat control knobs to high.
5. Wait 5 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted.
Tips
Bread Product
Bagels, wheat or rye bread or
products with high moisture
content.
Buttered or coated, such as
pastries
Frozen
2. Test the settings by placing a sample of the bread items to be
toasted onto the feed ramp. Place bagels or buns onto the feed ramp
with the cut side facing up.
For One-Sided Toasting
TOP heat control to the desired setting.
BOTTOM heat control to the OFF position.
Toast the Bread
1. Adjust the top and bottom heat control settings and conveyor as
needed for even toasting. Allow time for the toaster to adjust to new
heat settings before placing bread or sandwiches on the
2. For best performance do not overload the toaster. Wait a few
seconds before loading a second row of bread or sandwiches into
the toaster.
Suggestions
Use a slower conveyor speed.
Not recommended.
Must be thawed before toasting.
conveyor.