Oster BVSTDC3390 Manuel D'instructions page 5

BE F OR E U SIN G I T F OR TH E F I R S T TI M E
1. Read all instructions thoroughly.
2. Remove the coffee urn and all accessories from the packaging carefully.
3. Clean the coffee urn pot with a clean, damp cloth. Do not immerse the unit in any
liquid.
4. Wash the lid, coffee filter and water pipe with warm soapy water. Rinse each
thoroughly.
5. Place all parts back in the unit and close the lid.
6. Select a location for the coffee urn. The location should be in an open area on a flat
counter where the plug will reach an outlet.
7. Then, run a brew cycle with water only, without adding coffee.
8. When brewing is complete, unplug then coffee urn and discard the water. Allow the
coffee urn to cool.
Your coffee urn is now ready to use.
O P ER AT I N G IN S TR U C T I O NS
1. Remove the coffee filter and the water pipe out of the unit and then add water to the
desired level according to the number of cups of coffee you would like to brew (up to
a "MAX" level of 35 cups). To ensure the best coffee flavor, make sure to brew at least
10 cups at one time.
Note: Do not use hot water. Do not add water above the "MAX" level.
2. Place the water pipe and coffee filter back into the unit making sure the pipe fits into
the bottom of the coffee filter and the heating element (located at the bottom of the
pot).
3. Add the desired amount of ground coffee into the coffee filter. Note: Do not add too
much coffee. The top level of coffee should be lower than the edge of the coffee filter
by 2 cm (1 inch) or the coffee might overflow during the brewing process.
The following are suggested amounts:
You can adjust the amount of coffee according to your preference and the kind of
coffee used.
To Brew (150 ml cup)
10 cups
20 cups
30 cups
35 cups
4. To brew the coffee, close the lid by twisting it clockwise until the lock markings are
aligned.
Use this amount of Ground Coffee
4
1 Measuring Cup
1-3/4 Measuring Cups
2-1/4 Measuring Cups
2-1/2 Measuring Cups