Installation Instructions - Sunbeam HOSPITALITY SH3600 Serie Instructions D'installation

I
nstallatIon
Your Sunbeam showerhead attaches to any standard 1/2" threaded shower.
Tools: 1) Wrench or pliers,
2) Soft Cloth.
1. Remove your old showerhead from the shower arm with a wrench or pliers, turning
counterclockwise. Be careful not to loosen your shower arm.
N :
OTE If YOUR ExISTINg SHOwER ARM HAS AN INTEgRAL bALL jOINT
REpLACED wITH A STANDARD
ARM IS AVAILAbLE AT MOST HARDwARE STORES
2. Remove any old sealing material and clean all debris from the threads.
3. Wrap Plumber's tape evenly clockwise onto the threads. Do not use pipe compound.
Carefully thread swivel ball onto the end of the shower arm, over the tape, and hand
tighten as firmly as possible.
NOtE:
SHOULD ADDITIONAL TIgHTENINg bE NECESSARY
SwIVEL bALL wITH A SOfT CLOTH
wRENCH OR pLIERS
DO NOT TURN MORE THAN 1/4 TURN.
Position your Sunbeam showerhead as desired and tighten back of unit. Slowly turn on
cold water and check for leaks. If leaks occur, wrap a soft cloth around the swivel ball and
re-tighten with pliers. DO NOT OVER TIGHTEN.
o
peratIng
Turn the rotating portion of the showerhead to the desired setting.
The selector tab will align with the symbol designating which setting you have chosen:
Massage, Spray/Massage, Full Spray, Spray/Mist, Mist.
I
nstructIons
"
1/2
SHOwER ARM
,
TO pREVENT MARRINg AND TIgHTEN wITH
Backside
Swivel Ball
I
nstructIons
3
,
IT MUST bE
.
THIS STANDARD SHOwER
.
,
COVER THE