Proxxon LG/A2 Manuel page 7

Caution!
Drastically reduced operating times after the
charging process indicates that the battery
needs to be replaced!
If after inserting the battery into its designated
opening the light-emitting diode fl ashes instead
of glowing yellow continuously, the cause may
be a too high temperature, a defect, or the total
discharge of the battery.
• If the battery is too hot, the charging process
will start automatically after it cools down.
• If, on the other hand, the battery has a nor-
mal temperature but is totally discharged, the
charger will check if it still draws power or it
if is already defective.
• If the battery can be recovered, the yellow
light-emitting diode will glow continuously
after some time, signalling the successful
charging process.
• If the yellow light-emitting diode fl ashes, the
battery is defective and needs to be dispo-
sed of.
Disposal
Please do not dispose of the device in domestic
waste! The device contains valuable substances
that can be recycled. If you have any questions
about this, please contact your local waste
management enterprise or other corresponding
municipal facilities.
3 CE Declaration of conformity
Name and address of the manufacturer or dis-
tributor:
PROXXON S.A.
6-10, Härebierg
LU-6868 Wecker
Product designation:
Article No.:
On our sole responsibility, we declare that this
product conforms to the following directives
and normative documents:
2014/35/EC Low-voltage directive
DIN EN 60335-1/10.2012
DIN EN 60335-2-29/06.2019
2014/30/EU EMC directive
DIN EN 55014-1/08.2018
DIN EN 55014-2/01.2016
DIN EN 61000-3-2/03.2015
DIN EN 61000-3-3/03.2014
Date: 12.08.2019
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Appliance Safety Division
The CE document authorized agent is identical
with the signatory.
Charger LG/A2
29880
- 7 -