Depth Stop - LEMAN MOR375 Manuel D'utilisation

The fence (A) Fig. 5, can be moved in or out by loosening lever (B), sliding fence to the desired position
and tightening lever (B).
Fig5 Fig6

DEPTH STOP

A depth stop guide (A) Fig. 6, is provided to limit the depth of the chisel (B). To adjust the depth stop guide
(A), loosen handle (C) and lower head until the chisel (B) is at the desired depth. Lower depth stop guide
(A) until it is at the desired depth, tighten handle (C).
INSTALLING CHISEL & BIT
1. Loosen lock screw, shown in Figure 7.
Fig 7 Fig 8
2. Insert chisel bushing (with the hole facing forward) into the head. Tighten the screw just
enough to hold the chisel in place.
!
NOTE: Set the slot in the side of the chisel to the left or right, NOT to the front or back. This will allow
chips to escape when cutting mortises.
MS3816 Hollow Chisel Mortiser
８
V.03 01-03-2008
EN