Schauer Charge Master CM6A Manuel De L'utilisateur page 12

TROUBLE SHOOTING
Types of Indication
Problems
Charger No Indicator
does not lights on
work?
Charger has Fault RED
no DC LED is ON.
output?
No Charging Fault RED
Current? LED is
Flashing
Full / Float Fault RED
light won't LED is
come on? Flashing
Or Full LED
is Flashing
MAINTENANCE
The charger is maintenance free. If the power cord is damaged, the charger must be left to the
reseller for maintenance. The case should be cleaned occasionally. The charger should be
disconnected from the power while cleaning.
Possible Causes
- No AC power
- Output is short circuited
- Reverse polarity connection
to Battery
- Battery is severely
sulphated
- Battery has a damaged cell
- Overheat protection mode
- Battery capacity too large
for the battery charge and it
has timed out.
- Battery is defective
- Battery is severely
sulphated
Suggested Solution
- Check AC connections and make
sure Power Point is switched ON
- Check DC connection between
charger and battery and make sure
they are not short circuiting.
- Check that the crocodile clips
haven't fallen off the battery.
- Check that the crocodile clips / ring
terminals are connected to the
correct polarity.
- Check the Battery condition, age
etc.
- Battery may need replacement.
- Move battery & Charger to cooler
environment
- Check the charger specification
matches the battery capacity.
- Battery cannot be charged and
must be replaced.
- Charge rate selected might be too
low, switch charger off and on and
try a higher charge rate setting
providing it doesn't exceed the
maximum charge limit for your
battery.
12