Serial Numbers; Cleaning And Maintenance - Martinelli ISOFIX BASE 0+1 K Mode D'emploi

buttons on the handle and at the same time
rotate the handle as shown in the figure until
it clicks into position.
8• Pull the handle on the base and push the
base with the child car seat against the
vehicle seat until they can go no further.
IMPORTANT: It is possible to check that
•
the base is correctly positioned by looking
at the signals on the handle. OK (green)
indicates that the position is correct, NO
(red) indicates that the procedure has been
carried out incorrectly and must be repeated
until the handle only shows the term "OK".
9• To release the child car seat from the base:
raise the handle to its transport position,
push the lever on the backrest upwards and
at the same time lift the seat.
10• To release the base from the vehicle seat:
release the Isofix connectors from the fixing
points in the car by lifting the handle on the
base (Arrow A) and pulling the base in the
normal direction of travel (Arrow B). Pull the
handle (Arrow C) and push the connectors
back inside the base (Arrow D). Rotate the
support leg and place it in its housing (Arrow
E).
Connecting Viaggio1 Duo-Fix
and all its models
IMPORTANT: the car seat must be
attached without the child in it.
• Before connecting the car seat on the Isofix
base, ensure that the child car seat's Isofix
connectors are fully extended (Arrow A).
• If you have any difficulty fitting car seat
in your car, lift up or remove the vehicle's
headrests.
11• Remove the plastic casing attached to
the child car seat with the special release
switches (Arrows B and C).
12• Position the child car seat on the Isofix Base
0+1 K and insert the rear connectors of the
child car seat in the fixing points of the base
nearest to the vehicle seat (Arrow A).
• Press the front part of the child car seat until
it clicks into place (Arrow B).
IMPORTANT: The two signals behind the
base go from red to green to indicate that
the child car seat is properly attached to the
base.
13• Pull the handle on the base (indicated by
Arrow A) and push the base with the child
car seat against the vehicle seat until they
can go no further (indicated by Arrow B).
IMPORTANT: It is possible to check that
the base is correctly positioned by looking
at the signals on the handle. OK (green)
indicates that the position is correct, NO
(red) indicates that the procedure has been
carried out incorrectly and must be repeated
until the handle only shows the term "OK".
IMPORTANT: Once the procedure is
complete, move the base to check that both
Isofix points are actually attached.

Serial numbers

14• On the underside of the Isofix Base 0+1 K,
near the isofix connectors, the following
information is provided: product name, date
of manufacture and serial number of the
product itself (Fig. a).
The approval label is located on the Isofix
Base 0+1 K behind the compartment holding
the instruction sheet (Fig. b).
This information is required for any
complaints.

Cleaning and maintenance

• This product requires a small amount of
maintenance. Cleaning and maintenance
must only be carried out by adults.
• Clean the plastic parts periodically with a
damp cloth. Do not use solvents or other
similar products.
• Protect the product from atmospheric
agents: humidity, rain or snow. Extended
exposure to sunshine can cause colour
changes in many materials.
• Store the product in a dry environment.
How to read the approval label
This paragraph explains how to read the
approval label (the orange label located in
the instruction sheet compartment).
• The terms SEMI-UNIVERSAL class E and
class A indicate the compatibility of the
child car seat with vehicles fitted with Isofix
attachment systems.
10