Technical Specifications - Elta 7173N2 Mode D'emploi

CARE
For cleaning wipe the exterior of unit with a soft cloth. Never use fuel, thinners or any other solvents.
TROUBLESHOOTING
To solve the common problems, read and follow the troubleshooting list. If you still cannot solve the
problem, consult your nearest service dealer.
Symptom Cause
The fuse blown.
The unit cannot be
switched on.
The wire of the speaker touches
the chassis of the vehicle or the
like.
No sound or to low volume. The wires or the cable harness
are not connected correctly.
A speaker wire is short circuit
by a screw.
Bad sound quality
(distortions, interferences).
The speakers are not correctly
connected.
The antenna is not pulled out.
Bad radio reception.
The wire for powering the
automatic antenna is not
correctly connected.
20.
Solution
Check the wires for short-circuit
and renew the fuse by a new
one with same values.
Wire or insulate the speaker
wires correctly.
Check the wire connections
(see wiring).
Check the speaker wires.
Connect the plus and negative
poles of all speakers correctly.
Pull out the antenna completely.
Connect the wire correctly
(see wiring).

TECHNICAL SPECIFICATIONS

1. RADIO
Frequency range AM/FM (MW / VHF)
AM (MW) 525 - 1615 kHz
FM (VHF) 87.5 - 108 MHz
2. CASSETTE DRIVE
Tape speed 4.75 cm / sec.
Wow & Flutter less than 0.4%
Cassette mechanism auto stop
3. GENERAL
Voltage supply 12 Volt DC
Impedance of the speakers 4 - 8 Ω
Dimensions 178 mm (W) x 110 mm (D) x 44 mm (H)
Weight approx. 0.8 kg
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
21.