Safety Cautions - Halosense SaltAir ST-UV01 Manuel Du Propriétaire

Safety Cautions

To reduce the risk of fire or electric shock, do not immerse this device in water; for assistance refer to qualified
personnel only; never attempt to repair the device yourself.
Adapter is part of the equipment. Put the device near the socket. If an extension cord is used it must be suitable to
the power consumption of the device, otherwise overheating will occur.
The adapter insulate the device from the mains supply. Do not use in a place where it is difficult to disconnect from
the mains supply.
Do not place this device close to other electric devices which may be damaged or cause electric hazard in case of
an accidental saline solution spill.
Do not fill the water tank with water over 40℃ to avoid discoloration or deformation.
When the ambient temperature is below 0℃ pour out the water from the device.
Use only the measuring cup provided to add water to the tank, never fill directly from the tap.
Keep the device away from direct sunlight and heat sources, air conditioners or fans.
The device must be placed on a hard surface to assure proper air flow underneath.
Do not unplug with wet hand.
If there is an accidental spill, unplug the device first.
Do not touch the ultrasonic cell while the device is working.
Do not touch adapter output when the device is working.
Do not tilt or move the device after is filled or in use - it may cause water to get over electric parts and cause malfunc-
tion.
Do not use for more than 10 hours at a time. Wait 60 minutes before restart to avoid damaging the ultrasonic cell.
This device is not intended for use by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the device by
a person responsible for their safety.
Never allow it to be used by handicapped children or disabled individuals.
Push the power button 'OFF' and unplug the adapter from the mains supply to safely terminate the operation.
Accidental leakage / unit tipped over: turn OFF the power and remove cover; pour out any remaining water, tap
dry the unit and let it dry for 24 hours before use.
TROUBLESHOOTING
If the DEVICE is not working correctly, please check the following causes:
TROUBLE
DEVICE does not operate
Switch OFF early
No mist or abnormal mist
Aerosol with unpleasant smell
PROBABLE CAUSE
Power cable not plugged in
Not enough water in the tank
Not enough water
Too much water
Ultrasonic cell needs cleaning
Cover and inner cover not
installed properly
Restricted air intake port on the base
New machine
Saline solution left in the tank
for too long time, without use
4
SOLUTION
Plug in power cable; disconnect
and re-connect carefully
Add water to the tank
Fill tank with saline solution
Never fill tank over MAX line
Please refer to maintenance
instructions to clean the
ultrasonic cell correctly
Remove and re-install correctly,
so vapors can be released freely
Clean or free the air intake port
on the base
Open the water tank and leave it
for 12 hours in a cool, dry place
Clean the water tank and make
new saline solution