To Locate A Break In The Boundary Wire; Terms Of Use And Limitation Of Liability - Guardian Underground Fence Mode D'emploi

10. If Receiver Collar does not beep and the Test Light does not fl ash, replace the battery in the
Receiver Collar. If it still does not beep and the Test Light does not fl ash, contact the Customer
Care Center.
11. If the Receiver Collar beeps, there may be a complete or partial break in the Boundary Wire. See the
"To Locate a Break in the Boundary Wire" section.

To Locate a Break in the Boundary Wire

Please follow these steps in determining where you have a break in your Boundary Wire:
1. Locate your original splice(s) and verify they have a good, solid connection.
2. Check your yard to determine any possible damage to the Boundary Wire (e.g. recent digging, aerating,
rodent burrowing, or any other noticeable disturbance in your yard next to the Boundary Wire).
If you still cannot fi nd the break in the Boundary Wire, there are two options for locating it:
Option 1: Contact the Customer Care Center to purchase a Wire Break Locator that will locate the
break in the Boundary Wire.
Option 2: Follow the procedure below:
1. Unplug the Fence Transmitter.
2. Connect both ends of your twisted Boundary Wire to one Boundary
Wire Terminal.
3. Measure and cut a Test Wire which is half the length of your total
Boundary Wire footage.
4. Connect one end of Test Wire to the other Boundary Wire Terminal.
5. Locate the halfway point of your boundary and cut the Boundary Wire.
6. Splice the other end of the Test Wire to either side of your Boundary Wire
where you cut it in half.
7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the
Loop Indicator Light is on, you can assume the break is in the other half
of the Boundary Wire.
8. If the Loop Indicator Light did not come on, you may assume there is a break in this portion of the
Boundary Wire. However, there is a small chance of having more than one break in your system. Be
sure to check both halves of your entire loop.
9. Replace the damaged Boundary Wire with new Boundary Wire.
10. Reconnect the Boundary Wire to the Fence Transmitter.
11. Check the Loop Indicator Light. If the Loop Indicator Light is on, test the system with the
Receiver Collar.

Terms of Use and Limitation of Liability

1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modifi cation of the terms, conditions and
notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specifi c temperament of your pet may not
work with this Product. We recommend that you not use this Product if your pet is less than 8 pounds or if your pet is
aggressive. If you are unsure whether this is appropriate for your pet, please consult your veterinarian or certifi ed trainer.
Proper use includes reviewing the entire Guide provided with your Product and any specifi c Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or
provoke. Using this Product in a way that is not intended could result in violation of Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems
consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this
Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this
®
Product is offered.
Corporation be liable for any direct, indirect, punitive, incidental, special or
®
www.guardianpet.net
Test
Wire
19