Warnings And Safety Notes - RC System POWER X-80 Mode D'emploi

• Do not attempt use with device requiring greater current than Rated 40 amps.
• Do not allow to rain and to become wet.
• Only connect to AC mains outlet when in use at ail other time disconnect the power supply from AC mains outlet.
• Power supply may become warm during use or emit a slight buzzing sound. This is quit nom and can be disregarded.
• Do place the power supply on a non flammable surface when in use.
• This power supply is for indoor use only.
4. Usine as a charper (chareing with constant voltage, constant current) :
Charging Curve
V (max)
V (max)
A (max)
A (min)
Charging battery
12VLead-acid battery
6VLead-acid battery
Four-cell LiFe pack
Three-cell Lipo pack
Three-cell LiFe pack
Two-cell LiPo pack
Two-cell LiFe pack
e.g: 6VLead-acid battery: Constant current =

WARNINGS AND SAFETY NOTES

• This product isn't designed for use by children under the age of 14, it isn't a toy! This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a persan responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
• Protect the charger from dust, damp, rain, heat (e.g. direct sunshine) and vibration. It should only be operated in dry indoor
conditions.
• The case slots serve to cool the charger, and must not be covered or enclosed; set up the charger with space round it, so that
cooling air cm circulate unhindered.
• The charger is designed to be powered by a 220~240V AC main socket only. It is not permissible to modify the charger in any
way. You must not connect AC power to the DC input.
• The charger and the battery to be charged should be set up on a heat-resistant, noninflammable and non-conductive surface
before use. Never place the charger directly on a car seat, carpet or similar. Keep ail inflammable and volatile materials well
away from the charging area. Provide good ventilation. Defective batteries can explode or burn!
• The charge output sockets and connecting leads must not be modified, and must not be inter-connected in any way. There is a
danger of short-circuit between the charge outputs and the vehicle's bodywork when the charger is connected to the car battery.
The charge leads and connecting leads must not be coiled up when the charger is in use. Avoid shortcircuiting the charge output
or the model battery with the car bodywork. For this reason the charger must never be placed directly on the vehicle's bodywork.
• Never leave the charger running or connected to the car battery unsupervised.
• Only one battery may be connected at each output at any one time.
• The following types of battery must not be connected to the charger:
• Ni-Cd / Ni-MH batteries, lead-acid batteries with a nominal voltage of more than 12V or less than 6V, Lithium-Ion / Li-Mn /
Lithium-Polymer / LiFeP04 (LiFe) batteries with less than 2 cells and more than 3 cells (4 cells for LiFePO4).
• Batteries which require a different charge method from CC/CV or lead-acid types.
• Faulty or damaged cells or batteries.
• Batteries consisting of parallel-wired cells, or cells of different types.
• Batteries consisting of old and new cells, or cells of different makes.
• Non-rechargeable batteries (dry cells). Caution: explosion hazard!
• Batteries which are not expressly stated by the manufacturer to be suitable for the currents which this unit delivers during the
charge process.
• Packs which are already fully charged or hot, or only partially discharged.
• Batteries or cells fitted with an integral charge circuit or charge termination circuit.
• Batteries installed in a device, or which are electrically connected to other components.
T1 T2 (FULL)
Suitable voltage area
13.8~14.2V
6.9~7.1V
14.0-14.4V
12.3V
10.6-10.8V
8.2V
7.0-7.2V
adjustable area (V)
adjustable area (A)
T
Constant current
(1/5 ~ 1/10) x
(1 ~ 4) x
(1/2 ~ 2) x
7 Ah
5
= 1.4A
Accu-Capacity
1h
Accu-Capacity
1h
Accu-Capacity
1h