Switching On/Off - Hilti NURON TE 30-22 Mode D'emploi

5.9 Inserting accessory tool
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in damage to the product.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.10 Removing accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Pull the chuck ring back as far as it will go and remove the accessory tool.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on / off
1. To switch the product on, operate the control switch.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
2. To switch the product off, release the control switch.
6.2 Forward / reverse
▶ Set the forward / reverse switch to the desired direction of rotation.
6.3 Function selector switch
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.3.1 Drilling without hammering
▶ Set the function selector switch to this symbol:
6.3.2 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
6.3.3 Chisel positioning
▶ Set the function selector switch to this symbol:
▶ The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
6.3.4 Chiseling
▶ Set the function selector switch to this symbol:
6.4 Screwdriving
1. Change the chuck.
2. Set the forward/reverse switch to the desired direction of rotation.
10 English
8
9
10
11
.
.
.
.
2264907
*2264907*