Remote Control; Audio Recordings - Monacor DPR-10 Mode D'emploi

3 Connections
Prior to making or changing any connections,
switch off the DPR-10 and the units to be con-
nected .
1) Use an RCA cable to connect the jacks OUT-
PUT to a line level input, e . g . of a mixer or
amplifier (L = left channel, R = right chan-
nel) .
2) For MP3 recordings, connect an audio unit
with line level output (e . g . CD player, mixer)
to the jacks AUX INPUT .
3) For power supply, a regulated 12 V power
supply unit with a rating of 400 mA and
with a low-voltage plug of 5 .5 / 2 .1 mm
(outside / inside diameter) is required (e . g .
PSS-1205DC from MONACOR) . Connect
the power supply unit to the jack 12 V⎓:
Make sure to connect the positive pole to
the centre contact!
4 Operation
Switch on the unit by means of the button
the unit or the button POWER on the remote
control . will appear on the display .
Welcome
If neither a memory card nor a USB flash drive
is inserted,
NO USB

4.1 Remote control

1) Remove the battery compartment cover on
the rear side of the remote control . Insert
the batteries (2 × 1 .5 V, size AAA) as indi-
cated in the battery compartment . Close the
compartment with the cover .
If the remote control is not used for a
longer period of time, remove the batteries
as a precaution so that the remote control
will not be damaged in case the batteries
should leak .
2) When pressing a button, always point the
remote control towards the sensor "IR" .
Make sure that there are no obstacles be-
tween the remote control and the sensor .
3) When the operating range of the remote
control decreases, the batteries are dis-
charged and must be replaced .
Never put batteries in the household
waste . To protect the environment,
always take them to a special waste
disposal, e . g . collection container at
your retailer .
will appear on the display .
at
4.2 Replaying music titles
1) Connect a USB flash drive to the USB port
and/or
insert a memory card into the slot SD/ MMC
CARD (notched corner to the right) . To re-
move the card, push the card into the slot
until it disengages .
2) To start the replay, press the button II
PLAY/ PAUSE .
3) All other functions available during replay
are listed in the table on page 11 .
4) After operation, switch off the unit with the
button or POWER . The power supply unit
has a low power consumption even when
the DPR-10 has been switched off; there-
fore, disconnect the power supply unit from
the mains socket when the DPR-10 is not
used for a longer period of time .

4.3 Audio recordings

It is possible to make MP3 recordings from a
unit connected to the jacks AUX INPUT (e . g .
CD player) and to store them on a memory card
or a USB flash drive .
1) Make sure that the write protection of the
memory card or USB flash drive is not ena-
bled; if required, disable the protection .
PLAY
POWER
PAUSE
1 2 3
STOP
4 5 6
PROG
7 8 9
DISPLAY
0
ID3
FOLDER REV – SKIP – CUE
REPEAT FIND MUTE FUNC
REC DEL VOL– VOL+
9