Audio Streaming Via Bluetooth; Mp3 Playback Via Usb; Recalling Factory Settings - Blaupunkt 7 607 545 500 Mode D'emploi

Select the entry and press the PTT but-
➜
ton a second time to place the phone
call.
Briefly press the PTT button a second
➜
time if you did not select a specific en-
try to repeat the selection again.
The call starts and you can hear the
contact person over the loudspeakers
of the car sound system.

Audio streaming via Bluetooth

To transfer audio files to the car sound sys-
tem via Bluetooth, you must activate this
function on your cell phone. For this pur-
pose, the cell phone must be coupled with
the interface and support this function (see
the instructions of your cell phone and the
chapter "Connecting the cell phone with
the interface").

MP3 playback via USB

You can connect a removable USB device
with MP3 files with the interface to play
back MP3 files via the car sound system.
The car sound system must be switched
on.
For this purpose, no call or audio stream-
ing via Bluetooth may be active. However,
the cell phone may be connected with
the interface.
Connect the removable USB device to
➜
the USB cable of the interface.
On your car sound system, select CD
➜
changer (CDC) as the audio source (see
the instructions of the car sound sys-
tem).
10
479443_Bluetooth_alle.indb 10
The playback starts
Control the playback via the car sound sys-
tem. You can change titles and directories
via the buttons which are also used for the
CD changer playback (directory selection
with CD up/down, title selection with Track
up/down).

Recalling factory settings

You can recall the factory settings of the
interface to delete coupled cell phones
and phone books from the memory of the
interface.
For this purpose, no cell phone may be
connected with the interface.
Press and hold the PTT button for at
➜
least 30 seconds.
The interface is set to factory set-
tings.
19.05.2006 9:33:53 Uhr