Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL Expert TE-VC 1820 Mode D'emploi D'origine

Anleitung_TE_VC_1820_SPK7__ 31.05.12 10:35 Seite 10
GB
5.4 Suction nozzles
Dual-purpose nozzle (Fig. 1/2)
For dry vacuuming surfaces use the dual-purpose
nozzle (13).
Crevice nozzle (Fig. 1/2)
The crevice nozzle (19) is designed for vacuuming
solids and liquids in corners, edges and other areas
that are difficult to access.
Upholstery nozzle (Fig. 1/2)
For cleaning upholstery use the upholstery nozzle
(12).
5.5 Accessory holder (Fig. 3)
The wet and dry cleaner is equipped with a holder for
the space-saving storage of vacuum nozzles.
6. Operation
6.1 ON/OFF switch (Fig. 1)
Switch position 0:
Switch position I:
6.2 Dry vacuuming
For dry-vacuuming, use the pleated filter (15). In
addition, you can also fit the dirt bag. (see point 5.2)
Always ensure that the filters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam filter (16) (see point
5.2).
Check that the filter is securely fitted at all times.
Important!
When wet vacuuming, the floating safety switch (5)
closes when the maximum tank level is reached. In
doing so, the suction noise of the equipment will
change and become louder.
You must then switch off the equipment and empty
the tank.
Important!
The wet and dry vacuum cleaner is not suitable for
the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam filter.
6.4 Blowing
Connect the suction hose (11) to the blow connector
(10) on the wet and dry vacuum cleaner.
10
7. Cleaning, maintenance and ordering
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
b
b
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth and
some soft soap. Do not use cleaning agents or
solvents; these may be aggressive to the plastic parts
in the appliance.
7.3 Cleaning the container (8)
The container can be cleaned with a damp cloth and
some soft soap or under running water, depending on
the amount of dirt.
Off
On
7.4 Cleaning the filters
Cleaning the pleated filter (15)
Clean the pleated filter (15) regularly by carefully
patting it and cleaning it with a fine brush or hand
brush.
Cleaning the foam filter (16)
Clean the foam filter (16) with a little soft soap under
running water and allow it to air-dry.
7.5 Maintenance
At regular intervals and before each use, check that
the filters in the wet and dry vacuum cleaner are
securely fitted.
7.6 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
For our latest prices and information please go to
www.isc-gmbh.info
of spare parts
Important!
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
We recommend that you clean the appliance
immediately after you use it.
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required