Led Status Indicator - ROBBE-Futaba FASST WTR7 Guide Rapide

FASST 2.4GHz Wireless Trainer System
Wireless Trainer System for 2.4 GHz FASST systems. Com-
patible with the following RC systems: T6EXP, T7CP, T10CP,
T12FG, T12Z, FX-30, T14-MZ and FX-40, in seven-channel
mode.
Specification
Operating voltage:
Current drain:
Channel count:
Spot frequency spacing:
Frequency band:
Alternative:
Transmission system:
Weight: 13 g
Dimensions:
Temperature range:
System range:
Connections
The Wireless Trainer System is supplied complete with a
connecting lead. Connect the servo plug end to the Wireless
Trainer System, and the 6-pin micro-plug to the Trainer
socket on the Teacher transmitter.
For the linking process the
WTR7 requires a power
supply - either via the Trai-
ner socket or a separate
receiver battery. During the
linking procedure you
must ensure that nobody in the vicinity is operating a
second 2.4 GHz FASST transmitter. This is the method of
linking the WTR7 to the Pupil transmitter, which must be
active in 7-channel mode: hold the "LINK" button on the
WTR7 pressed in for about two seconds.
Operating Instructions WTR7
No. F 1414
5 V from Teacher transmitter
approx. 75 mA
7
2048 kHz
2.4 ... 2.4835 GHz
2.4 ... 2.454 GHz
FSK
40 x 22.4 x 13.2 mm
-15 ... +55°C
approx. 100m

LED STATUS INDICATOR

Green
Red LED Function/Status
LED
OFF ON Transmitter signal NOT received
ON OFF Transmitter signal received
Transmitter signal received, but code
Flashing OFF
number incorrect
Alternate flashing Irrecoverable error
Safety Notes
• If the Pupil transmitter is switched off while Trainer
mode is active, the Teacher transmitter assumes con-
trol of the model.
• It is essential to ensure that the 'linking' process has
been carried out correctly.
• If you make a change to the frequency after linking, the
linking procedure must be repeated with the WTR7.
• Check that the connectors are plugged in firmly.
• When in Trainer mode, check all functions before flying
the model.
Conformity Declaration
robbe Modellsport GmbH & Co. KG hereby declares that this
radio control system component satisfies the fundamental
requirements and other relevant regulations contained in the
appropriate CE Directives. The original Conformity Declara-
tion can be viewed on the Internet under www.robbe.com:
click on the logo button marked "Conform" which is included
in each device description.
equipment separately from the general household waste
when it reaches the end of its useful life. Take your apparatus
to your local waste collection point or recycling centre. This
applies to all countries of the European Union, and to other
European countries with a separate waste collection system.
You must not dispose of electronic
equipment in the normal domestic
waste. That is the meaning of the
symbol shown here.
This symbol means that you must
dispose of electrical and electronic