AEG GYT11012CB Notice D'emploi page 9

1.4 Respecting this indications, will
mantain the warranty rights,
ensures the declared properties
of the products and warrant the
complete reliability.
Before assembling the
!
OK
hose, please check the
OK!
appropriate crimping
of both sides of the
hoses.
Don't tighten by tools.
Hand-tighten O-ring
seal connectors until
feeling a mechanical
rest.
Don't set the hose in
the wall.
NO!
Tighten the hose
without any twis or
tension.
Prolonged contact wit
any substance, even
scarcely aggressive, can
cause external braid
damage and subsquent
flexible burst.
Before bending the
2 x Ø
hose please consider a
straight part of 2 times
the external diameter.
Mantain minimum bend
radius (DN= nominal
internal diameter):
DN
DN8 = 0mm
DN10 =
DN1 =
Hand-tighten
connectors with gasket
seal (nuts) then apply
1/ turn using an
appropriate wrench.
Do not expose the
hose to lateral stress
nor overtight by any
tool (ex. during the
installation of the
faucet stud or the drain
pop-up lever).
NO!
ENGLISH 9
= 2 mm
mm
mm