Component Identification; Threading The Machine - Kasanova CIH000005 Manuel D'instruction

SEWING MACHINE AND SEWING KIT
8

COMPONENT IDENTIFICATION

1. Needle Clam
2. Bobbin Compartment
3. Needle
4. Take-up Lever
5. Tension Screw
6. Thread Spindle
7. Bobbin Holder
8. Hand Wheel
9. Power Switch
10. Speed Button
11. Battery Compartment
12. Power Adapter Jack
13. Foot pedal Jack
14. Presser Foot Lever
15. Bobbin Winder
BONUS ACCESSORIES
1 Needle
1 Threader
4 Bobbins
1 Foot pedal
OPERATING INSTRUCTIONS
1. Before inserting batteries, turn the machine OFF by ensuring that the power
switch (9) is extended out.
2. Put 4 AA batteries into the battery compartment on the bottom of the machi-
ne/insert adapter into power adapter jack (12).
3. Turn ON the sewing machine and machine will start sewing immediately.
(Note: lf the machine is used with included pedal, the machine should stay
on OFF. lt will only work when you push down the pedal.)
4. Make sure the machine is properly threaded and fabric is in the right posi-
tion for sewing before you turn the machine on.

THREADING THE MACHINE

1. Raise thread spindle by pulling it upward until it's fully extended.
2. Piace thread spool on the thread spindle.(For bobbin spindle:pull out the