Etac Molift RgoSling StandUp Manuel D'utilisation page 9

5
B5. Fasten the sling to the suspension on the
U-shaped suspension by pulling the rope down
into connection point. On the V-shaped suspen-
ions the ropes are fastened by pulling the rope
into the ropelock/connection point from the inside
and out. The ropes should be pulled down in the
locks so that they are sufficiently fastened to avoid
slipping of the ropes when lifting.
Sit to stand lift
7
Etac Molift RgoSling / www.molift.com / www.etac.com
6
B6. Check the length, and make sure the ropes are
fastened with equal length on both sides.
If the patient is large and heavy, it may be neces-
sary to pull the ropes from the outside in on the
V-shaped suspension in order to increase the
width between the connection points
B7. The patient's weight ensures that the
rope locks into the suspension. The user
should lean back slightly when lifting, and
if possible hold onto the handles.
The waist belt should be retightened when
lifting begins and when the sling is loaded
The user should not stand fully upright
during the transfer because this is uncom-
fortable for the user.
When using RgoSling Standup with support
the support part can be removed when the
user is in standing position.
9.